# Modeling Uncertainty

(→Example) |
(→Example) |
||

Line 21: | Line 21: | ||

In this example, we will vary a single MEAM parameter and look at the influence with respect to the dislocation velocity of a single material, called "Material 1". In this study, we will vary the parameter b2 by approximately +/-1% and assume a parameter uncertainty of approximately 5%. | In this example, we will vary a single MEAM parameter and look at the influence with respect to the dislocation velocity of a single material, called "Material 1". In this study, we will vary the parameter b2 by approximately +/-1% and assume a parameter uncertainty of approximately 5%. | ||

− | [[image:Uncertaintyplot.jpg|thumb|right| | + | [[image:Uncertaintyplot.jpg|thumb|right|300px| Figure 1]] |

===Step 1=== | ===Step 1=== |

## Revision as of 12:29, 1 April 2017

## Contents |

# Uncertainty

This topic has been taken by Student 1 for 2017 Contribution

## Objective

This page will provide information on how to model uncertainty using the MEAM parameter calibration (MPC) tool and Large-scale Atomic/Molecular Massively Parallel Simulator (LAMMPS). On this page, the central finite difference approximation is used as an example to help users to understand how to model the uncertainty of the response of your system with respect to certain variables.

In this example, the "response" of our system will be the dislocation velocity determined from LAMMPS. Additionally, "variables" can be inputs that contribute to the response of your system. In this example, these variables will be will be the MEAM parameters that are used to input into LAMMPS.

## Theory

The uncertainty of the response of your system can be approximated using a one-factor-at-atime perturbation methodology. This method uses the central difference approximation to estimate the sensitivity of your response with respect to input variables. This sensitivity can be expressed as:

where f() is the model function, Xi is the model input parameter, X0,i is the base value of a parameter, +/-i is the perturbation size around the base parameter, and DeltaXi is the difference between the perturbed input parameters. The perturbation size typically assumes a +/-1% perturbed factor. The uncertainty based on the sensitivity of an input can be determined from the following equation:

where Uf is the total uncertainity propagated through the model, df/dx is the model sensitivity in the equation prescribed above, N is the total number of parameters, and Uxi is the input parameter uncertainty. This parameter uncertainty term will have to depend on previous studies with respect to it's variance on the response your system. Conservatively, it can be assumed that a 5% parameter uncertainty can be used.

## Example

In this example, we will vary a single MEAM parameter and look at the influence with respect to the dislocation velocity of a single material, called "Material 1". In this study, we will vary the parameter b2 by approximately +/-1% and assume a parameter uncertainty of approximately 5%.

### Step 1

Calibrate your MEAM potential with respect to Density Functional Theory. This requires the use of elastic constants from experiments or literature to calibrate your material to DFT. The MEAM parameters we will be using is shown below for our "Material".

### Step 2

We will need to run LAMMPS to determine the dislocation velocity for an edge dislocation. This was done at several applied shear stress levels (10 to 1200 MPa).

### Step 3

### Step 4